How To Fix Garbage Disposal Back Up

But if the sink has some water already that s fine though make sure its just three to four inches.

How to fix garbage disposal back up. Remove the plunger and unplug the garbage disposal drain. To fix a clogged garbage disposal turn off the disposal using the circuit breaker and shine a flashlight down into the disposal to see the clog. When you re sure the drain is working properly you can do a bigger flush by putting a stopper over the disposal opening filling up the sink basin with hot water and quickly pulling out the stopper. Avoid using your hands to protect yourself from possible injury. Let at least three to four inches of water into that sink.

Remove the rubber catch or cover if needed and slide a hex wrench or wooden spoon into the disposal. Confirm that the garbage disposal drain is plugged in. Plug the drain you just plunged and run water into the garbage disposal drain. If your garbage disposal starts working then run some water through it and check for any leaks. Disconnect the drain trap and remove the trap and the discharge drain pipe.

Pour a mix of baking soda and vinegar down your drain. How to fix garbage disposal with water that comes back up. Check for clogs or obstructions and clean out any you find. If your garbage disposal is draining extremely slowly or not at all then the issue probably comes from its drain trap which is the s or. Then wait about thirty minutes to allow these ingredients to break down whatever might be responsible for the blockage.

If it does not flow down repeat plunging on the garbage. Remove the bolts holding the discharge pipe to the disposal. Usually the fix involves disassembling the drain trap and discharge pipe and removing any food waste clogging the pipes. Point a flashlight down into your garbage disposal and pull out any visible blockages with tongs.