How To Patch Drywall Anchor Holes

Once you have your holes drilled take a hammer and lightly tap the plastic anchors into the holes you just drilled.

How to patch drywall anchor holes. Allow to dry as you work your way through this how to patch drywall project. First scrape out any paint from the two cross slots using a utility knife or paring knife 2 fill the hole deeply with spackle or joint compound using a 1 putty knife. If you glob this stuff on the anchor and put the anchor back in the same hole you might have to use some painter s tape to hold it in place and let it dry. No tape wood or screws needed. 4 cover the tape.

Gorilla glue and similar products expand when drying and is used a lot in furniture making for that reason. Then put a few cups into a drywall pan and use your 6 in. Place a piece of paper or mesh drywall joint tape over the hole and wipe flat using the putty knife. Immediately apply a thin layer of compound on top of the tape. Hang a smallish weight on the thread and let dry overnight.

This is my super easy and effective patch for holes up to 8 inches. Carefully tap the anchor into the wall with a hammer until the collar is flush with the drywall surface. Overfill it slightly leaving a small mound. Knife to spread it. Lay a 1 8 in thick bed of patch drywall compound over the joints and press paper tape into the compound with a flexible 6 in.

9 attach a screw into the anchor using a. As an amazon associate i m. Mix a tablespoon or two of water into three or four cups of the joint compound to make it easier to spread. For the best results use topping or all purpose joint compound. To get tighter joints.

Allow the material to dry and sand lightly with a piece of drywall sandpaper. If you are using the self drilling type then just simply screw them into the wall. Tools i use often. Then patch it with the larger drywall piece you cut out if you cut it out carefully. Press a wall anchor into the drilled hole.